Now assembly of your roof trusses can finally begin.
Setting roof trusses by yourself.
Fashion your own set of plywood gusset plates by cutting thick sheets of plywood to fit over each site where one joist meets another.
Take two rafters and connect the peak at the plumbed corner you created.
Because truss sets move from one end of the house to the other you ll need to pick a side to start the set.
Carry the trusses in one at a time and turn them upside down.
Cut plywood gusset plates to fasten together lightweight trusses.
Set the heel of the truss up on the wall on each end.
Start on one side of the building structure and set the truss against the wall.
Do this by nailing the triangular gusses to the rafters.
With a 12ft ceiling and a 24 foot span it seeme.
Common rafters must be measured according to the angle and pitch of the roof then cut them into the perfect shape and be sure to have one of them at every 20 inch distance across the wall.
In order to do this once you have chosen a size you can measure along the sides of the walls and mark where they will need to be attached.
When you are installing prefabricated roof trusses you have to make sure that you are dong it in a way that is safe and that will be the most efficient.
Make sure to space each truss the same width apart.
Have someone up on the peak of the trusses that are already set to catch it as it comes up.
The beam extends to the far end of the roof hanging over.
Typically you ll want to start the truss set on the farthest side of the house or the opposite end of where the crane will set up.
In 2nd videio jon explans how to put trussesup by yourself.
Measure the jack rafter s length cut them perfectly and place one at every 20 inch distance across the wall.
Repeat the process until all the trusses are set in place.
The best way to assemble the trusses is to lay each rafter and bottom chord on the ground in the desired shape.
This is how i set up up trusses by myself on my barn project.
After setting the second truss in the same manner workers attach a ridge beam to the peak of both trusses.
Jon quote it isn t as hard as you think.
Then push the peak up and over with a 2x4 about 14 long.
